Harcros Chemicals - Lavasol 6

Enhanced TDS

Labeling Claims

Not Listed In California Proposition 65

Product Benefits

Concentrated cleaner for most efficient shipping and handling provides efficient shipping and handling
Buffered pH to maintain optimum cleaning performance throughout cleaning cycle
Best results when used in conjunction with either LavasolTM 9 or LavasolTM 7.
Classified for use in membrane systems producing drinking water (ANSI/NSF Standard 60)

Markets

HI&I Care

Applications

HI&I Care — Home Care

Application Area

Membranes

Mixing Instructions

Inspect all cleaning system components to include CIP tank, hoses, and cartridge filters. Flush or replace if necessary. Fill cleaning tank with RO permeate or DI water. Turn on agitator or tank recirculation pump.
Slowly add LavasolTM 6 to cleaning tank (1 gal [3.8 L] of LavasolTM for every 50 gal [189 L] of water). Mix thoroughly. The solution pH should match product specification. If necessary, adjust pH with a membrane–approved chemical such as caustic, citric, sulfuric or hydrochloric acid. The solution should be heated up to 45 ̊C to improve cleaning efficacy.
Circulate solution in the same direction as the feed flow. Typical circulation times are 30-90 minutes.* PWT recommends cleaning each stage of the system separately. Maximum flow rate per pressure vessel is 40 gpm (152 Lpm) for 8-inch elements and 10 gpm (38 Lpm) for 4-inch elements. Maximum pressure for cleaning is 60 psig (4.2 kg/cm2).
In cases of heavy fouling, divert the first 10-20% of cleaning solution to drain to prevent re- deposition of removed solids.
Rinse with RO permeate before returning system to service. When returning unit to service, divert product water to drain until any residual cleaning solution has been rinsed from system.

Product Uses

For use on reverse osmosis (RO), nanofiltration (NF), ultrafiltration (UF) and micro-filtration (MF) membranes
Formulated to dissolve inorganic precipitants from the membrane surface
To aid in the removal of carbonates, phosphates, metal hydroxides and similar inorganic foulants

Physical Form

Liquid

SDS Physical and Chemical Properties

Note: * PWT : Depending on the nature of the fouling, a soak period may be necessary for optimum results. Please contact PWT or your local distributor for custom cleaning procedure, or consult PWT’s Technical Bulletin 503 for further cleaning recommendations.

Supplied by

PWT Chemicals

Packaging Information